Consistency Measurement - Technical Papermaking

Consistency Measurement


Testing the consistency of a stock is the same as consistency of water solution. Consistency is the term given to the amount of solid matter within a body of liquid. The higher the consistency the more solid matter is present within the same volume of liquid. Consistency is measured in percentage; it’s a percentage/ ratio of solid matter to water in a certain volume.


To find the consistency we need to test the amount of dry content within a set volume of water. For example if we wanted the consistency of 100ml of water, and tested 25 gram of dry solids the consistency would be about 25%.

To capture the solid content within a solution a filter paper is used. Firstly the filter paper is weighed at 0% moisture (previously oven dried) and recorded. The stock sample is weighed (1g = 1ml) and recorded. The weighed stock sample is filtered through a vacuum and rinsed making sure all of the solids from the sample are on the sheet. The filtered solids and the filter paper go into the oven to remove all of the remaining moisture.

Once the sample leaves the oven it is weighed and recorded. This formula is used to calculate the consistency below.

Consistency=  (Mass of Solids)/(Volume of Liquid)

We have to calculate the mass of the solids captured on the filter paper, this is calculated below;

Mass of Solids=Total dry weight-Filter paper weight

Here are a list of results that I took from measuring the consistencies of a pulp preparation plant's stock flows through two fractionators and Long fiber screens.